1937 Buick four door sedan front doors-$150
These doors are from a four door 1937 Buick Special or Century. Roadmaster and Limited models are different.
They also may fit other GM cars, Oldsmobile and Pontiac of the same vintage but I am not sure.
I was told the GM cars shared body parts, I am leaving it up to you to decide if these will fit your car.
They need work but are in pretty good condition for parts from a 70+ year old car. They have surface rust and
some rust out at the bottoms but are complete with all the inner mechanisms that work. They are missing
exterior door handles and the glass will need to be replaced.
I am asking $150 for the pair OBO. Will consider trade for other '37 Buick parts or '48-50 Ford truck parts.
I prefer that the doors be picked up at my location but I will ship. I will not give shipping costs, it is up
to you to arrange all shipping. I will strap to a pallet and load onto a truck. The door measures
roughly 40"Wx48"Hx8"D, and weighs about 60 lbs each.
|
|
|
|
The following parts came out of a 1940 Buick Coupe.
I bought these parts along with a bunch of other parts that I am using
on my 1937 Buick build. These '40 parts do not fit my '37. The person
I bought the '40 parts from told me he was street rodding the couple and
wasn't going to use these parts. He told me the Coupe was restored within
the last ten years and had very low mileage, the parts are in almost like new
condition and have a lot of life left in them.
In addition to the parts I
have listed below I also have the following items I will sell as soon as I remove the
parts I am keeping and plan to use on my '37. I will be using the '40 brake systyem parts
for my '37:
Front suspension, including shocks, lower control arms, brake backing plates
and spindles-$100
|
|
1940 Buick clutch pressure plate and disc-$100
This clutch assembly came out of a low mileage 1940 Buick Coupe.
|
|
|
|
|
|
|
|
|
1940 Buick clutch release fork and rod-$20
|
|
|
|
|
1940 Buick front engine mounting plate with motor mount-$50
This plate comes with the two front motor mounts, they will need to be revulcanized but will be good for cores.
|
|
|
|
|
|
|
|
|
|
|